[Mar-2026] Get 100% Real Free CCNA 200-301 Sample Questions
Accurate 200-301 Questions with Free and Fast Updates
Cisco 200-301 is a certification exam for network professionals who want to validate their skills in implementing and managing Cisco networks. 200-301 exam is designed to test the candidate's knowledge and expertise in various network technologies, including network access, IP services, security fundamentals, automation, and programmability. Cisco Certified Network Associate Exam certification is intended for individuals who want to pursue a career in network engineering and administration.
Cisco 200-301 exam is a valuable certification for IT professionals who want to establish their expertise in networking. It is recognized globally and is highly respected in the industry. Cisco Certified Network Associate Exam certification can open up various career opportunities, such as network administrator, network engineer, technical support specialist, and many more. It is also a prerequisite for many advanced Cisco certifications, such as the CCNP and CCIE certifications.
NEW QUESTION # 269
Refer to the exhibit. Which VLAN ID is associated with the default VLAN in the given environment?
- A. VLAN 5
- B. VLAN 20
- C. VLAN 1
- D. VLAN 10
Answer: C
NEW QUESTION # 270
Drag and drop the SNMP components from the left onto the descriptions on the right.
Answer:
Explanation:
NEW QUESTION # 271
which command must you enter to guarantee that an HSRP router with higher priority becomes the HSRP primary router after it is reloaded?
- A. standby version 2
- B. standby 10 preempt
- C. standby 10 priority
- D. standby 10 version 1
Answer: B
NEW QUESTION # 272
Refer to the exhibit.
An engineer built a new L2 LACP EtherChannel between SW1 and SW2 and executed these show commands to verify the work. Which additional task allows the two switches to establish an LACP port channel?
- A. Configure the interface port-channel 1 command on both switches.
- B. Change the channel-group mode on SW1 to active or passive.
- C. Change the channel-group mode on SW1 to desirable.
- D. Change the channel-group mode on SW2 to auto
Answer: B
NEW QUESTION # 273
Refer to the exhibit.
All traffic enters the CPE router from interface Serial0/3 with an IP address of 192 168 50 1 Web traffic from the WAN is destined for a LAN network where servers are load-balanced An IP packet with a destination address of the HTTP virtual IP of 192 1681 250 must be forwarded Which routing table entry does the router use?
- A. 192.168.1.0/24 via 192.168.12.2
- B. 192.168.1.192/26 via 192.168.14.4
- C. 192.168.1.128/25 via 192.168.13.3
- D. 192.168.1.224/27 via 192.168.15.5
Answer: C
NEW QUESTION # 274
A Cisco engineer at a new branch office is configuring a wireless network with access points that connect to a controller that is based at corporate headquarters Wireless client traffic must terminate at the branch office and access-point survivability is required in the event of a WAN outage Which access point mode must be selected?
- A. Lightweight with local switching disabled
- B. OfficeExtend with high availability disabled
- C. FlexConnect with local switching enabled
- D. Local with AP fallback enabled
Answer: B
NEW QUESTION # 275
An engineer must configure a core router with a floating static default route to the backup router at 10.200.0.2.
Answer:
Explanation:
NEW QUESTION # 276
Refer to the exhibit.
Which two commands were used to create port channel 10? (Choose two )
- A. Option B
- B. Option E
- C. Option C
- D. Option A
- E. Option D
Answer: C,D
NEW QUESTION # 277
Which functionality does an SVI provide?
- A. OSI Layer 3 connectivity to switches
- B. OSI Layer 2 connectivity to switches
- C. remote switch administration
- D. traffic routing for VLANs
Answer: D
NEW QUESTION # 278
Drag and drop the descriptions of file-transfer protocols from the left onto the correct protocols on the right.
Answer:
Explanation:
NEW QUESTION # 279
Refer to the exhibit.
When PC-A sends traffic to PC-B, which network component is in charge of receiving the packet from PC-A verifying the IP addresses, and forwarding the packet to PC-B?
- A. Load balancer
- B. Layer 2 switch
- C. Router
- D. firewall
Answer: C
Explanation:
PC--A and PC-B are not in the same network. Switches send traffic in layer 2 and within the same VLA while routers route traffic to different subnet and at layer 3.
NEW QUESTION # 280
Refer to the exhibit. An engineer is configuring a new router on the network and applied this configuration. Which additional configuration allows the PC to obtain its IP address from a DHCP server?
- A. Configure the ip helper-address 172.16.2.2 command under interface Gi0/0
- B. Configure the ip address dhcp command under interface Gi0/0
- C. Configure the ip dhcp relay information command under interface Gi0/1.
- D. Configure the ip dhcp smart-relay command globally on the router
Answer: A
NEW QUESTION # 281
Refer to the exhibit. Traffic that is flowing over interface TenGigabitEthernet0/0 experiences slow transfer speeds.
What is the reason for the issue?
- A. queuing drops
- B. heavy traffic congestion
- C. a speed conflict
- D. a duplex incompatibility
Answer: C
NEW QUESTION # 282
PC1 tries to send traffic to newly installed PC2. The PC2 MAC address is not listed in the MAC address table of the switch, so the switch sends the packet to all ports in the same VLAN. Which switching concept does this describe?
- A. spanning-tree protocol
- B. frame flooding
- C. MAC address table
- D. MAC address aging
Answer: B
NEW QUESTION # 283
Drag drop the descriptions from the left onto the correct configuration-management technologies on the right.
Answer:
Explanation:
NEW QUESTION # 284
Which output displays a JSON data representation?
- A. Option B
- B. Option A
- C. Option C
- D. Option D
Answer: C
Explanation:
Explanation
JSON data is written as name/value pairs.A name/value pair consists of a field name (in double quotes), followed by a colon, followed by a value:"name":"Mark"JSON can use arrays. Array values must be of type string, number, object, array, boolean or null.For example:{"name":"John","age":30,"cars":[ "Ford", "BMW",
"Fiat" ]}JSON can have empty object like "taskId":{}
NEW QUESTION # 285
Refer to the exhibit.
The network administrator must establish a route by which London workstations can forward traffic to the Manchester workstations.
What is the simplest way to accomplish this?
- A. Configure a dynamic routing protocol on London to advertise all routes to Manchester.
- B. Configure a dynamic routing protocol on Manchester to advertise a default route to the London router.
- C. Configure a static route on London to direct all traffic destined for 172.16.0.0/22 to 10.1.1.2.
- D. Configure Manchester to advertise a static default route to London.
- E. Configure a dynamic routing protocol on London to advertise summarized routes to Manchester
- F. Configure a static default route on London with a next hop of 10.1.1.1.
Answer: C
NEW QUESTION # 286
What routing protocol use first-hand information?
- A. distance-vector
- B. path-vector
- C. link-state
Answer: C
NEW QUESTION # 287
Drag and drop the network protocols from the left onto the correct transport services on the right.
Answer:
Explanation:
NEW QUESTION # 288
Which two actions influence the EIGRP route selection process? (Choose two.)
- A. The router must use the advertised distance as the metric for any given route.
- B. The router calculates the best backup path to the destination route and assigns it as the feasible successor.
- C. The router calculates the reported distance by multiplying the delay on the exiting interface by 256.
- D. The advertised distance is calculated by a downstream neighbor to inform the local router of the bandwidth on the link.
- E. The router calculates the feasible distance of all paths to the destination route.
Answer: B,E
Explanation:
Section: IP Connectivity
NEW QUESTION # 289
......
Cisco 200-301 certification exam is a highly respected certification in the field of networking. It is recognized worldwide and is an essential requirement for many networking jobs. Cisco Certified Network Associate Exam certification is designed to validate the candidate's knowledge and skills in the field of networking, and it is an excellent way to demonstrate to employers that you have the necessary skills and knowledge to excel in this field. If you are interested in a career in networking, the Cisco 200-301 certification exam is an excellent place to start.
200-301 Study Guide Realistic Verified Dumps: https://www.dumpsfree.com/200-301-valid-exam.html
Self-Study Guide for Becoming an Cisco Certified Network Associate Exam Expert: https://drive.google.com/open?id=1WwMLewFw6fY_1ZX2XSzBK5gFgKvcuWxb