The D-VXR-OE-23 PDF Dumps Greatest for the EMC Exam Study Guide!
Read Online D-VXR-OE-23 Test Practice Test Questions Exam Dumps
NEW QUESTION # 84
A VxRail administrator is concerned that the NDC is a single point of failure on your VxRail nodes.
What can be done to increase redundancy in this scenario?
- A. Spread network traffic across other nodes in the cluster
- B. Spread network traffic across two ports on a PCIe adapter
- C. Spread network traffic across NDC and PCIe adapter ports
- D. Spread network traffic across two NDC
Answer: C
NEW QUESTION # 85
VxRail Manager provides a software stack for a software-defined data center.
Which layers are part of the stack?
- A. Security, management, and network
- B. Network, storage, and security
- C. Management, network, and storage
- D. Storage, security, and management
Answer: C
NEW QUESTION # 86
An administrator wants to perform maintenance on a VxRail system.
Which configuration should be used for the VxRail Cluster Health Monitoring before starting the maintenance activity?
- A. Disabled
- B. Maintenance mode
- C. Enabled
- D. Suspended
Answer: B
NEW QUESTION # 87
A customer has a large storage capacity and low I/O performance requirements.
Which VxRail solution is the best fit?
- A. P Series
- B. E Series
- C. S Series
- D. V Series
Answer: C
NEW QUESTION # 88
What is a consideration when choosing between vSphere Encryption and vSAN Encryption?
- A. vSphere Encryption addresses fears of media theft vSAN Encryption addresses fears of a rogue admin
- B. vSphere Encryption does not support deduplication and compression vSAN Encryption allows deduplication and compression
- C. vSphere Encryption is for data-at-rest vSAN Encryption is for data-in-flight
- D. vSphere Encryption applies to the entire vSAN datastore vSAN Encryption is on a per VM basis.
Answer: B
NEW QUESTION # 89
An administrator wants to expand a VxRail cluster by one node. The new node arrived with code that is newer than the cluster version.
What action must be taken before the new node can be added to the cluster successfully?
- A. The new node requires no action and will be downgraded automatically and added to the cluster
- B. The cluster must be upgraded to match the code level of the new node before the node can be added
- C. The SD card on the new node must be exchanged with a new SD card with the required code version
- D. The cluster must be RASR reset to match the code level of the new node before the node can be added
Answer: B
NEW QUESTION # 90
VxRail Stretched cluster deployment with eight nodes at each data site is being proposed.
What is the latency requirement between each data site and the Witness site?
- A. Less than 100 ms
- B. Less than 5 ms
- C. Less than 10 ms
- D. Less than 200 ms
Answer: D
NEW QUESTION # 91
An administrator wants to configure vSAN Fault Domains.
After selecting the VxRail cluster in the vSphere client, where should the administrator navigate to complete this task?
- A. Configure > VxRail > Fault Domains
- B. Configure > vSAN > Fault Domains
- C. Configure > VxRail > Disk Management > Fault Domains
- D. Configure > vSAN > Services > Fault Domains
Answer: B
NEW QUESTION # 92
What is the default time, in minutes, of the vSAN object repair timer?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION # 93
A VxRail administrator is concerned that the Integrated NIC is a single point of failure on VxRail nodes.
How should the network traffic be balanced to increase redundancy?
- A. Across two Integrated NICs
- B. Across two different ports of the same Integrated NIC.
- C. Across two ports on a PCIe NI
- D. Across Integrated NIC and PCIe NIC ports
Answer: D
NEW QUESTION # 94
Using the VxRail Plugin, what does VxRail administrator use to compare the current component version state against the expected component version state?
- A. Health Monitoring
- B. Compliance Reports
- C. VxRail VxVerify
- D. Skyline Reports
Answer: B
NEW QUESTION # 95
What is the minimum recommended number of hosts in a vSAN cluster for FTT = 2 and FTM = Erasure Coding?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION # 96
A company has deployed VxRail independent of an existing VMware environment. VxRail hosts and VMs are configured into the organization's DNS server host records. The VxRail deployed VDS is being used.
Which VxRail deployment model has been implemented by the company?
- A. External vCenter with external DNS
- B. Internal vCenter with internal DNS
- C. Internal vCenter with external DNS
- D. External vCenter with internal DNS
Answer: C
NEW QUESTION # 97
What is true about Multitrack VxRail cluster expansion?
- A. VxRail System VMs run on the nodes in the first rack
- B. VxRail cluster can be expanded up to a maximum of 4 racks
- C. VxRail nodes in the same cluster within a rack can be on different subnets
- D. All VxRail networks are routable by default
Answer: A
NEW QUESTION # 98
Where is the VxRail Dashboard located in the vSphere client?
- A. Menu > Administration
- B. Hosts and Clusters > Monitor > VxRail
- C. Hosts and Clusters > Configure > VxRail
- D. Menu > VxRail
Answer: D
NEW QUESTION # 99
What is the order of steps to generate the SolVe procedure to add a capacity drive to a VxRail node?
Answer:
Explanation:
NEW QUESTION # 100
What is the correct sequence of steps in enabling NIC redundancy across NDC and PCIe ports for a VxRail cluster?
- A. 1. Assign the required PCIe adapter
2. Configure ToR switches to support VxRail network traffic on switch ports that are connected to the PCIe ports
3. Unassign the NDC adapters that are not required
4. Cable VxRail PCIe ports to ToR switches - B. 1. Assign the required PCIe adapter
2. Cable VxRail PCIe ports to ToR switches
3. Unassign the NDC adapters that are not required
4. Configure ToR switches to support VxRail network traffic on switch ports that are connected to the PCIe ports - C. 1. Unassign the NDC adapters that are not required
2. Configure ToR switches to support VxRail network traffic on switch ports that are connected to the PCIe ports
3. Assign the required PCIe adapter
4. Cable VxRail PCIe ports to ToR switches - D. 1. Unassign the NDC adapters that are not required
2. Assign the required PCIe adapter
3. Configure ToR switches to support VxRail network traffic on switch ports that are connected to the PCIe ports
4. Cable VxRail PCIe ports to ToR switches
Answer: B
NEW QUESTION # 101
Which SolVe procedures are customer viewable and can be found in the Upgrade section?
- A. Software Upgrade
Stretched Cluster Upgrade
Secure Connect Gateway Upgrade - B. Firmware Upgrade
iDRAC Upgrade
vCenter Upgrade - C. Network Configuration Upgrade
BIOS Customization
External Storage Integration. - D. Firmware Upgrade
Hardware Upgrade/Expansion
Software Upgrade
Answer: D
NEW QUESTION # 102
An organization wants to implement a zero data loss protection solution for its virtual machines.
What is the recommended solution when using a VxRail system?
- A. VMware site recovery
- B. Stretched clusters
- C. RecoverPoint for VMs
- D. PowerProtect software
Answer: B
NEW QUESTION # 103
As a VxRail administrator, you must determine how long the rebuild will take after experiencing a hardware failure in the cluster.
When could you locate this information in the vSphere Web Client?
- A. Monitor > vSAN > Physical Disks
- B. Monitor > vSAN > Virtual Objects
- C. Monitor > vSAN > Resyncing Components
- D. Monitor > vSAN > Health
Answer: C
NEW QUESTION # 104
In which environment is it recommended to enable vSAN deduplication and compression?
- A. VDI Using Linked Clones
- B. Mixed Workloads
- C. OLTP Databases
- D. VDI Using Full Clones
Answer: D
NEW QUESTION # 105
A VxRail has been configured with the VxRail-deployed vCenter Server option.
Which service VMs can be optionally hosted on the VxRail cluster?
- A. vRealize Log Insight and Secure Remote Services/VE
- B. VxRail Manager, vCenter Server, and Platform Services Controller
- C. vCenter Server, Platform Services Controller, and Secure Remote Services/VE
- D. VxRail Manager and Secure Remote Services/VE
Answer: A
NEW QUESTION # 106
An administrator wants to implement a disaster recovery solution. Two sites are available. The primary site uses VxRail and the secondary site uses a non-vSAN VMware environment.
Which technology minimizes data loss with the smallest recovery point objective for this scenario?
- A. vSphere Replication
- B. Stretched Cluster
- C. VMware HA
- D. RecoverPoint for VMs
Answer: D
NEW QUESTION # 107
Dell EMC VxRail All-Flash nodes have been deployed in a Stretched Cluster configuration.
A storage policy has been configured with:
- PFTT = 1
- SFTT = 0
- FTM = Default
What protection will a VMDK have with this storage policy?
- A. RAID 1 cross-site RAID 5 locally
- B. No cross-site protection RAID 1 locally
- C. RAID 1 cross-site No local protection
- D. RAID 1 cross-site RAID 1 locally
Answer: C
NEW QUESTION # 108
......
D-VXR-OE-23 Certification All-in-One Exam Guide Jul-2024: https://www.dumpsfree.com/D-VXR-OE-23-valid-exam.html