Free Cisco 350-501 Exam Questions and Answer from Training Expert DumpsFree
Top Cisco 350-501 Courses Online
Cisco 350-501 certification exam, also known as Implementing and Operating Cisco Service Provider Network Core Technologies, is a challenging exam designed to validate the knowledge and skills of IT professionals in managing and operating service provider networks. Implementing and Operating Cisco Service Provider Network Core Technologies certification is ideal for those looking to advance their careers in the service provider industry and want to demonstrate their expertise in network security, automation, and virtualization.
Preparation for 350-501 exam requires a comprehensive understanding of network concepts and protocols, along with hands-on experience in implementing and troubleshooting service provider networks. Candidates taking 350-501 exam must also have knowledge of Cisco equipment and their capabilities. 350-501 exam is designed to test the individual’s practical knowledge of troubleshooting tools and techniques and analytics.
NEW QUESTION # 43
Refer to the exhibit.
What is the result of this configuration?
- A. Router 1 and the TACACS+ server maintain one open connection between them.
- B. Router 1 and the TACACS+ server maintain one open connection between them only when network administrator is accessing the router with password ciscotest.
- C. Router 1 opens and closes a TCP connection to the TACACS+ server every time a user requires authorization.
- D. Router 1 opens and closes a TCP connection to the TACACS+ server every time a user requires authentication.
Answer: B
NEW QUESTION # 44
Which configuration enables BGP FlowSpec client function and installation of policies on all local interfaces?
- A.
- B.
- C.
- D.
Answer: C
Explanation:
The correct configuration for enabling BGP FlowSpec client function and installation of policies on all local interfaces is flowspec address-family ipv4 install interface-all local. This command configures the router to accept FlowSpec policies from a BGP peer and apply them to all local interfaces. The flowspec keyword enables the BGP FlowSpec client function, address-family ipv4 specifies the address family, and install interface-all local ensures that the policies are installed on all local interfaces. References := Implementing and Operating Cisco Service Provider Network Core Technologies course.
NEW QUESTION # 45
Refer to the exhibit.
An engineer wants to determine which paths are best, second best, third best, and fourth best. Drag and drop the peer addresses on the left to the corresponding BGP best-path selection order on the right.
Answer:
Explanation:
Explanation
Best - 50.50.50.2
2nd Best - 40.40.40.2
3rd Best - 20.20.20.2
44th Best - 30.30.30.2
NEW QUESTION # 46
Refer to the exhibit.
Routers R2 and R3 are Level 1/Level 2 IS-IS routers that redistribute 198 18.x.x/24 prefixes to routers R5 and R6 In the Level 1 area R2 Is to be the preferred router for all redistributed prefixes in the Level 1 are a. Which configuration sets this preference?
- A. Option A
- B. Option C
- C. Option B
- D. Option D
Answer: A
NEW QUESTION # 47
Which two routing protocols support Cisco MPLS TE tunnels? (Choose two.)
- A. RIP
- B. EIGRP
- C. IS-IS
- D. BGP
- E. OSPF
Answer: C,E
Explanation:
* Cisco MPLS TE tunnels can be established using IS-IS and OSPF as the routing protocols. These protocols allow the creation of traffic-engineered paths within the MPLS network.
Implementing and Operating Cisco Service Provider Network Core Technologies course materials.
NEW QUESTION # 48
Refer to the exhibit.
An engineer is configuring router R1 for OSPFv3 as shown. Which additional configuration must be performed so that the three active interfaces on the router will advertise routes and participate in OSPF IPv6 processes?
A)
B)
C)
- A. Option A
- B. Option C
- C. Option B
Answer: A
NEW QUESTION # 49
Drag and drop the functions from the left onto the Path Computation Element Protocol roles on the right.
Answer:
Explanation:
NEW QUESTION # 50 
Refer to the exhibit. Which task completes the configuration?
- A. Specify the activate neighbor 192.168.1.2 under the IPv4 address family
- B. Specify the source interface in the neighbor statement
- C. Specify the local-as value in the neighbor statement
- D. Specify the maximum number of prefixes that R1 receives from neighbor 192.168.1.2
Answer: A
Explanation:
Section: Networking
NEW QUESTION # 51
Refer to the exhibit:
Which statement describes the effect of this configuration?
- A. It modifies the default policy map to allow all HTTP traffic through the router
- B. It creates an ACL named WEB that filters HTTP traffic.
- C. It applies a service policy to all interfaces remarking HTTP traffic
- D. It matches HTTP traffic for use in a policy map
Answer: D
NEW QUESTION # 52
Which fact must a network engineer consider when planning to deploy RSVP-TE FRR?
- A. FRR protects MPLS LDP and RSVP-TE LSPs.
- B. PLR prefers FRR NHOP backup tunnels over NNHOP tunnels.
- C. PLR prefers FRR NNHOP backup tunnels over NHOP tunnels.
- D. The FRR backup tunnel reserves the total bandwidth of all protected tunnels
Answer: B
Explanation:
RSVP-TE Fast Reroute (FRR) is a mechanism that provides protection switching for MPLS TE LSPs. The Point of Local Repair (PLR) will prefer to use a next-hop (NHOP) backup tunnel over a next-next-hop (NNHOP) backup tunnel when both are available. This preference is due to the fact that NHOP backup tunnels can provide faster rerouting around the failure point, minimizing traffic disruption and packet loss.
NEW QUESTION # 53
Refer to the exhibit.
An engineer is implementing Auto-RP and reviewing the configuration of the PE-A. Which configuration permits Auto-RP messages to be forwarded over this interface?
- A. PE-A(config-if)#ip pim sparse-dense-mode
- B. PE-A(config-if)#no ip pim bsr-border
- C. PE-A(config-if)#ip igmp version 3
- D. PE-A(config-if)#ip pim sparse-mode
Answer: A
NEW QUESTION # 54
A customer of an ISP requests support to setup a BGP routing policy. Which BGP attribute should be configured to choose specific BGP speakers as preferred exit points for the customer AS?
- A. highest local preference outbound
- B. lowest multi-exit discriminator
- C. highest local preference inbound
- D. lowest local preference inbound
Answer: A
Explanation:
In BGP, the Local Preference attribute is used to influence the exit point from an AS (Autonomous System). A higher local preference value is preferred, and all routes received inherit the local preference value of the route that is installed in the IP routing table. So, configuring a higher local preference outbound will make specific BGP speakers as preferred exit points for customer AS. Reference := Cisco
NEW QUESTION # 55
Refer to the exhibit.
Router 4 is added to the network and must be in the same area as router 1. Which NET should the engineer assign?
- A. 49.0111.0000.0000.0001.00
- B. 49.0001.0000.0000.0004.00
- C. 49.0011.0000.0000.0003.00
- D. 49.0011.0000.0000.0002.00
Answer: C
NEW QUESTION # 56
According to RFC5305 on IS-IS extensions for traffic engineering, what is the 4-octet sub-TLV type 10 of extended IS-IS reachability TLV type 22?
- A. TE default metric
- B. maximum reservable link bandwidth
- C. IPv4 neighbor address
- D. administrative group (color)
Answer: B
Explanation:
RFC 5305 extends the IS-IS protocol for traffic engineering by specifying new information that an Intermediate System (router) can place in Link State Protocol Data Units (LSPs). Sub-TLV type 10 of the extended IS-IS reachability TLV type 22 is used to specify the maximum reservable link bandwidth. This is an important parameter for traffic engineering as it defines the amount of bandwidth that can be reserved by traffic engineering algorithms for use in constrained-path computations for MPLS traffic engineering Label Switched Paths (LSPs). References: RFC 53051.
NEW QUESTION # 57
Refer to the exhibit.
Refer to the exhibit. In the service provider network, routers PE1, PE2, and PE4 have access to the internet and provide access to customer networks. Router PE3 is used for access to other customer systems. In accordance with a new SLA, an engineer is updating settings on this network so that router CE1 accesses the internet via PE1 instead of PE2. Which two tasks must the engineer perform to complete the process? (Choose two.)
- A. On PE1, configure the internet VRF with import route target 102:102.
- B. On PE2, configure the internet VRF with import route target 102:102.
- C. On PE2 and PE3, configure the internet VRF with import route target 101:101.
- D. On PE1 and PE4, configure the internet VRF with import route targets 102:102 and 104:104.
- E. On PE2, configure the CE1 VRF with import route target 101:101.
Answer: A,E
Explanation:
https://www.cisco.com/c/en/us/support/docs/mpls-vpns/multiprotocol-label-switching-mpls/23986-mpls-vpns-config-example.html
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/mp_l3_vpns/configuration/15-mt/mp-l3-vpns-15-mt-book/mp-bgp-mpls-vpns.html
NEW QUESTION # 58
Refer to the exhibit. Which two statements about the ISIS topology are true? (Choose two.)
- A. R1 and R4 are Level 2 neighbors
- B. All four routers are operating as Level 1 routers only.
- C. All four routers are operating as Level 2 routers only.
- D. All four routers are operating as Level 1-2 routers.
- E. R1 and R2 are Level 2 neighbors.
Answer: D,E
Explanation:
R1 and R4 are level 1 and 2 neighbors as as area is common so they will form level 1 and level 2.
NEW QUESTION # 59
Drag and drop the functionalities from the left onto the correct target fields on the right.
Answer:
Explanation:
NEW QUESTION # 60
......
Cisco 350-501 exam is part of the Cisco Certified Network Professional (CCNP) Service Provider certification track. Candidates who pass the exam are eligible for the CCNP Service Provider certification, which is a globally recognized certification for service provider network professionals. The CCNP Service Provider certification demonstrates the candidate's expertise and mastery of service provider network technologies, making them a valuable asset to any organization that relies on these technologies.
New (2026) Cisco 350-501 Exam Dumps: https://www.dumpsfree.com/350-501-valid-exam.html
350-501 Practice Dumps - Verified By DumpsFree Updated 590 Questions: https://drive.google.com/open?id=1CTLqmoLRkWoBByztDAPacYUzo7N-wzlf