Authentic Best resources for JN0-681 Test Engine Practice Exam
[2021] JN0-681 PDF Questions - Perfect Prospect To Go With DumpsFree Practice Exam
NEW QUESTION 16
Which two statements define the use of route targets and route distinguishers in an EVPN? (Choose two.)
- A. Route distinguishers ensure that routes from different client remain unique within the data center domain
- B. Route targets ensure that routes from different clients remain unique within the data center domain
- C. Route distinguishers identify the VRF into which the route should be placed
- D. Route targets identify the VRF into which the route should be placed
Answer: A,D
NEW QUESTION 17
You are configuring VXLAN. and you must ensure that all switches for the multicast groups advertise their existence and learn about other VTEPs In this scenario. which protocol will accomplish this task?
- A. BOP
- B. EVPN
- C. PIM
- D. OSPF
Answer: C
NEW QUESTION 18 
Referring to the exhibit, PE1 and PE2 are acting as MPLS Layer 3 VPN PEs to provide the DCI between DC1 and DC2, which are IP Fabrics. Leaf 1 and Leaf 2 are QFX5100 Series devices acting as VXLAN Layer 2 Gateways using EVPN signaling for the same VXLAN segment.
Which statement is correct about the Edge1 device in this scenario?
- A. Edge1 must be configured for BGP labeled unicast on its PE1-facing interface.
- B. Edge1 must be configured for MP-BGP using EVPN signaling.
- C. Edge1's routing table must contain an IP route to both Leaf1 and Leaf2.
- D. Edge1 must be configured for MP-BGP using L3VPN signaling.
Answer: C
NEW QUESTION 19
You are configuring VXLAN, and you must ensure that all switches for the multicast groups advertise their existence and learn about other VTEPs.
In this scenario, which protocol will accomplish this task?
- A. EVPN
- B. OSPF
- C. BGP
- D. PIM
Answer: A
NEW QUESTION 20
Referring to the exhibit, which two MAC addresses are learned from the local side of the MC-LAG link?
- A. 4c:96:14:e8:c6:fd and 4c:96:14:e8:f0:21
- B. 4c:96:14:e8:f0:21 and 4c:96:14:e8:a6:16
- C. 4c:96:14:e8:c6:fe and 4c:96:14:e8:a6:16
- D. 4c:96:14:e8:c6:fd and 4c:96:14:e8:a6:16
Answer: C
NEW QUESTION 21
Referring to the VTEP output shown in the exhibit, which two statements are true? (Choose two.)
- A. The MAC address 52:54;00 5e 88 6a belongs to a local host.
- B. The. MAC address 52:54:00 5e 88 6a belongs to a remote host.
- C. The MAC address 52:54:00 2c 4b:a2 belongs to a local host.
- D. The MAC address 52:54:00 2c 4b:a2 belongs to a remote host.
Answer: B,D
NEW QUESTION 22
Referring to the exhibit, not all routes are being exchanged by EBGP peers.
In this scenario, which BGP parameter would solve this problem?
- A. mulcipach mulciple-as
- B. mulcihop
- C. mulcipach
- D. as-override
Answer: D
NEW QUESTION 23
Host1 and host2 are connected to an EVPN signaled VXLAN overlay, and must have Layer 3 connectivity.
The VNI and VLAN assignments are shown in the exhibit.
In this scenario, which two statements are true? (Choose two.)
- A. The VNI assigned to the host1 link must be the same as the VNI assigned to the host2 link.
- B. The ESI assigned to the host1 link will be different from the ESI assigned to the host2 link.
- C. A Layer 3 gateway can be configured on the leaf devices.
- D. A Layer 3 gateway can be configured on the spine devices.
Answer: C,D
NEW QUESTION 24
You are troubleshooting an L3VPN that is part of an EVPN/MPLS DCI. You notice that the EVPN overlay BGP session toward 10.29.50.4 is unable to establish.
Why is the BGP session failing to establish?
- A. There is no route for 192.168.5.5 in VPN.inet.0.
- B. The route-distinguishervalue on the local PE is incorrect.
- C. There is no route for 192.168.5.5 in inet.3.
- D. The vrf-table-labelvalue is not configured in the remote PE.
Answer: D
NEW QUESTION 25
You are having management connectivity problems with a mixed-mode Virtual Chassis.
Which statement is correct in this scenario?
- A. The master RE's me0 MAC address should match the MAC address of the vme.
- B. The current me0 MAC address should match the MAC address of the vme.
- C. Each member's me0 MAC address should match the MAC address on the vme.
- D. Each member's me0 MAC address should not match the MAC address of the vme.
Answer: A
NEW QUESTION 26
Which EVPN route type would be used in DCI situation in which the IP subnets between data center are complete unique?
- A. Type 2
- B. Type 4
- C. Type 3
- D. Type 5
Answer: D
NEW QUESTION 27
Referring to the exhibit, PE1 and PE2 are acting as MPLS Layer 3 VPN PEs to provide the DCI between DC1 and DC2, which are IP Fabrics. Leaf1 and Leaf2 are QFX5100 Series devices acting as VXLAN Layer 2 Gateways using EVPN signaling for the same VXLAN segment.
Which statement is correct about the Edge1 device in this scenario?
- A. Edge1's routing table must contain an IP route to both Leaf1 and Leaf2.
- B. Edge1 must be configured for BGP labeled unicast on its PE1-facing interface.
- C. Edge1 must be configured for MP-BGP using L3VPN signaling.
- D. Edge1 must be configured for MP-BGP using EVPN signaling.
Answer: D
NEW QUESTION 28
You are deploying a spine-and-leaf IP Fabric in your data center using EBGP.
In this scenario, which three statements are true? (Choose three.)
- A. EBGP does not require a next-hop self-policy.
- B. Each leaf must peer to every other leaf.
- C. Each leaf must peer to each spine.
- D. Each device should also run an IGP to advertise loopback interfaces.
- E. Each device should you use a different autonomous system number.
Answer: A,C,E
NEW QUESTION 29
You are designing a Layer 3 fabric underlay using EBGP. You will implement an EVPN-signaled VXLAN overlay on the Layer 3 fabric.
In this scenario, what must you do in the underlay to ensure that the VXLAN overlay will be able to function properly?
- A. The underlay should support the PIM protocol.
- B. The underlay should advertise the host-connected interfaces on all leaf devices.
- C. The underlay should be configured with a separate VRF for each potential tenant.
- D. Each device in the underlay should advertise its loopback address.
Answer: D
NEW QUESTION 30 
Referring to the exhibit, what is the MAC address of the IRB interface on router PE1?
- A. 1:100::0::100::a
- B. 2.91.223.216:100
- C. 2.10.255.0.1:100
- D. a8:d0:e5:54:0d:10
Answer: D
NEW QUESTION 31
You are establishing an IP Fabric where your QFX10002-72Q spine devices are connecting to leaf devices. Each leaf is a Virtual Chassis comprised of ten EX4300s.
What is the maximum number of leaf devices supported in this scenario?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
NEW QUESTION 32
After configuring an IP fabric using EBGP as your routing protocol, you notice that not all of the routes are showing up in the routing tables. You have verified that all adjacencies have formed, and that all policies are in place and configured properly.
In this scenario, which statement is true?
- A. The routers have not been configured using the add-pathparameter.
- B. The routers have not been configured using the bfd-liveness-detectionparameter.
- C. The routers have not been configured with the multipath multiple-asparameter.
- D. The routers have not been configured using the multihopparameter.
Answer: D
NEW QUESTION 33
You created an IP Fabric based on IBGP. You noticed that ECMP load sharing is not working. In this scenario, what is the problem?
- A. BGP route reflectors only reflect the best route.
- B. A route input policy needs to be added on all non-route reflectors to allow ECMP.
- C. Each member of the IP Fabric needs a different autonomous system number.
- D. ECMP load sharing is only supported on 40GbE and 100GbE interfaces.
Answer: A,B
NEW QUESTION 34
Which two statements define the use of route targets and route distinguishers in an EVPN? (Choose two.)
- A. Route distinguishers identify the VRF into which the route should be placed.
- B. Route distinguishers ensure that routes from different clients remain unique within the data center domain.
- C. Route targets identify the VRF into which the route should be placed.
- D. Route targets ensure that routes from different clients remain unique within the data center domain.
Answer: B,C
Explanation:
Explanation
NEW QUESTION 35
What is the purpose of the command shown in the exhibit?
- A. to disable the multicast group 239.0.0.1 across the entire VXLAN.
- B. to stop the reception of transit multicast traffic when there are no interested receivers attached to the local VTEP.
- C. to disallow IGMP requests for the group 239.0.0.1 from hosts attached to the local VTEP.
- D. to stop the transmission of transit multicast traffic when there are no interested receivers attached to a remote VTEP.
Answer: D
NEW QUESTION 36
You created an IP Fabric based on IBGP. You noticed that ECMP load sharing is not working.
In this scenario, what is the problem?
- A. BGP route reflectors only reflect the best route.
- B. A route input policy needs to be added on all non-route reflectors to allow ECMP.
- C. Each member of the IP Fabric needs a different autonomous system number.
- D. ECMP load sharing is only supported on 40GbE and 100GbE interfaces.
Answer: A,B
NEW QUESTION 37
......
Best updated resource for JN0-681 Online Practice Exam: https://www.dumpsfree.com/JN0-681-valid-exam.html