[Apr 18, 2024] NSE7_EFW-7.0 Exam Dumps PDF Guaranteed Success with Accurate & Updated Questions
Pass NSE7_EFW-7.0 Exam - Real Test Engine PDF with 165 Questions
NEW QUESTION # 87
Refer to the exhibit, which contains partial output from an IKE real-time debug.
Based on the debug output, which phase 1 setting is enabled in the configuration of this VPN?
- A. auto-discovery-shortcut
- B. auto-discovery-receiver
- C. auto-discovery-forwarder
- D. auto-discovery-sender
Answer: B
NEW QUESTION # 88
An administrator cannot connect to the GIU of a FortiGate unit with the IP address 10.0.1.254. The administrator runs the debug flow while attempting the connection using HTTP.
The output of the debug flow is shown in the exhibit:
Based on the error displayed by the debug flow, which are valid reasons for this problem? (Choose two.)
- A. HTTP administrative access is configured with a port number different than 80.
- B. Redirection of HTTP to HTTPS administrative access is disabled.
- C. The packet is denied because of reverse path forwarding check.
- D. HTTP administrative access is disabled in the FortiGate interface with the IP address 10.0.1.254.
Answer: A,D
NEW QUESTION # 89
Which two configuration commands change the default behavior for content-inspected traffic while FortiGate is in conserve mode? (Choose two.)
- A. set av-failopen off
- B. set av-failopen pass
- C. set fail-open enable
- D. set ips fail-open disable
Answer: A,C
Explanation:
https://docs.fortinet.com/document/fortigate/7.2.4/administration-guide/194558/conserve-mode
NEW QUESTION # 90
Refer to the exhibit, which contains the debug output of diagnose dvm device list.
Which two statements about the output shown in the exhibit are correct? (Choose two.)
- A. There are pending device-level changes yet to be installed on Local-FortiGate.
- B. The policy package has been modified for Local-FortiGate.
- C. The FortiGate configuration is in sync with latest running revision history.
- D. ADOMs are disabled on the FortiManager
Answer: A,C
NEW QUESTION # 91
Refer to the exhibit, which shows a FortiGate configuration.
An administrator is troubleshooting a web filter issue on FortiGate. The administrator has configured a web filter profile and applied it to a policy; however, the web filter is not inspecting any traffic that is passing through the policy.
What must the administrator change to fix the issue?
- A. The administrator must increase webfilter-timeout.
- B. The administrator must disable webfilter-force-off.
- C. The administrator must change protocol to TCP.
- D. The administrator must enable fortiguard-anycast.
Answer: D
NEW QUESTION # 92
Which two statements about bulk configuration changes made using FortiManager CLI scripts are correct? (Choose two.)
- A. When run on the Remote FortiGate directly, administrators do not have the option to review the changes prior to installation.
- B. When run on the Device Database, you must use the installation wizard to apply the changes to the managed FortiGate device.
- C. When run on the All FortiGate in ADOM, changes are automatically installed without the creation of a new revision history.
- D. When run on the Policy Package, ADOM database, changes are applied directly to the managed FortiGate device.
Answer: A,B
NEW QUESTION # 93
Examine the IPsec configuration shown in the exhibit; then answer the question below.
An administrator wants to monitor the VPN by enabling the IKE real time debug using these commands:
diagnose vpn ike log-filter src-addr4 10.0.10.1
diagnose debug application ike -1
diagnose debug enable
The VPN is currently up, there is no traffic crossing the tunnel and DPD packets are being interchanged between both IPsec gateways. However, the IKE real time debug does NOT show any output .
Why isn't there any output?
- A. The IKE real time shows the phases 1 and 2 negotiations only. It does not show any more output once the tunnel is up.
- B. The log-filter setting is set incorrectly. The VPN's traffic does not match this filter.
- C. The IKE real time debug shows error messages only. If it does not provide any output, it indicates that the tunnel is operating normally.
- D. The IKE real time debug shows the phase 1 negotiation only. For information after that, the administrator must use the IPsec real time debug instead: diagnose debug application ipsec -1.
Answer: B
NEW QUESTION # 94
View the exhibit, which contains the output of a debug command, and then answer the question below.
Which of the following statements about the exhibit are true? (Choose two.)
- A. The local FortiGate has been elected as the OSPF backup designated router.
- B. The local FortiGate's OSPF router ID is 0.0.0.4
- C. Port4 is connected to the OSPF backbone area.
- D. In the network on port4, two OSPF routers are down.
Answer: B,C
NEW QUESTION # 95
View the central management configuration shown in the exhibit, and then answer the question below.
Which server will FortiGate choose for antivirus and IPS updates if 10.0.1.243 is experiencing an outage?
- A. 10.0.1.242
- B. 10.0.1.240
- C. 10.0.1.244
- D. One of the public FortiGuard distribution servers
Answer: D
NEW QUESTION # 96
An administrator is running the following sniffer in a FortiGate: diagnose sniffer packet any "host 10.0.2.10" 2
What information is included in the output of the sniffer? (Choose two.)
- A. Port names.
- B. Ethernet headers.
- C. IP headers.
- D. IP payload.
Answer: C,D
NEW QUESTION # 97
Which of the following conditions must be met for a static route to be active in the routing table? (Choose three.)
- A. The link health monitor (if configured) is up.
- B. The next-hop IP address belongs to one of the outgoing interface subnets.
- C. There is no other route, to the same destination, with a higher distance.
- D. The next-hop IP address is up.
- E. The outgoing interface is up.
Answer: A,B,E
NEW QUESTION # 98
Refer to the exhibit, which shows the output of a debug command.
Which two statements about the output are true? (Choose two.)
- A. The local FortiGate OSPF router ID is 0.0.0.4.
- B. Port4 is connected to the OSPF backbone area.
- C. The local FortiGate is the backup designated router.
- D. In the network connected to port4, two OSPF routers are down.
Answer: A,B
NEW QUESTION # 99
An administrator wants to capture encrypted phase 2 traffic between two FortiGate devices using the built-in sniffer.
If the administrator knows that there is no NAT device located between both FortiGate devices, which command should the administrator run?
- A. diagnose sniffer packet any 'ah'
- B. diagnose sniffer packet any 'udp port 500'
- C. diagnose sniffer packet any 'ip proto 50'
- D. diagnose sniffer packet any 'udp port 4500'
Answer: C
Explanation:
Enterprise_Firewall_7.0_Study_Guide-Online.pdf p. 443 Phase 2 : ESP => IP protocol 50 This command will capture any packets that use the IP protocol number 50, which is ESP (Encapsulating Security Payload). ESP is used to encrypt and authenticate the phase 2 traffic between two FortiGate devices1.
NEW QUESTION # 100
When using the SSL certificate inspection method for HTTPS traffic, how does FortiGate filter web requests when the browser client does not provide the server name indication (SNI) extension?
- A. FortiGate uses the requested URL from the user's web browser.
- B. FortiGate uses CN information from the Subject field in the server's certificate.
- C. FortiGate blocks the request without any further inspection.
- D. FortiGate switches to the full SSL inspection method to decrypt the data.
Answer: B
NEW QUESTION # 101
An administrator cannot connect to the GIU of a FortiGate unit with the IP address 10.0.1.254. The administrator runs the debug flow while attempting the connection using HTTP.
The output of the debug flow is shown in the exhibit:
Based on the error displayed by the debug flow, which are valid reasons for this problem? (Choose two.)
- A. HTTP administrative access is configured with a port number different than 80.
- B. Redirection of HTTP to HTTPS administrative access is disabled.
- C. The packet is denied because of reverse path forwarding check.
- D. HTTP administrative access is disabled in the FortiGate interface with the IP address 10.0.1.254.
Answer: A,D
NEW QUESTION # 102
Refer to the exhibit, which contains the partial output of the get vpn ipsec tunnel details command.
Based on the output, which two statements are correct? (Choose two.)
- A. Hub2Spoke1 is configured on interface wan2.
- B. Hub2Spoke1 is a policy-based VPN.
- C. Anti-replay is disabled.
- D. Phase 2 authentication is set to sha1 on both sides.
Answer: A,D
NEW QUESTION # 103
View the exhibit, which contains the output of a diagnose command, and then answer the question below.
Which statements are true regarding the output in the exhibit? (Choose two.)
- A. FortiGate used 209.222.147.3 as the initial server to validate its contract.
- B. Servers with the D flag are considered to be down.
- C. FortiGate will probe 121.111.236.179 every fifteen minutes for a response.
- D. Servers with a negative TZ value are experiencing a service outage.
Answer: A,C
Explanation:
A - because flag is Failed so fortigate will check if server is available every 15 min D-state is I , contact to validate contract info
NEW QUESTION # 104
Examine the following partial output from a sniffer command; then answer the question below.
What is the meaning of the packets dropped counter at the end of the sniffer?
- A. Number of packets that matched the sniffer filter and were dropped by the FortiGate.
- B. Number of packets that didn't match the sniffer filter.
- C. Number of packets that matched the sniffer filter but could not be captured by the sniffer.
- D. Number of total packets dropped by the FortiGate.
Answer: C
NEW QUESTION # 105
......
Fortinet NSE7_EFW-7.0 exam is a challenging but rewarding certification that can help IT professionals stand out in a competitive job market. Whether you are a seasoned IT professional or just starting out in your career, this certification can help you gain the skills and knowledge you need to succeed in the field of network security.
Get New NSE7_EFW-7.0 Certification Practice Test Questions Exam Dumps: https://www.dumpsfree.com/NSE7_EFW-7.0-valid-exam.html
Real NSE7_EFW-7.0 Exam Dumps Questions Valid NSE7_EFW-7.0 Dumps PDF: https://drive.google.com/open?id=1m8sK3G8FAn_A2BOblH0mmz0DH-2MXoBK